Assembly Guide

ASSEMBLING INSTRUCTIONS:
1. Take left and right rack rails and unfold
them. Place left rack rail and right rack rail
next to each other so that the equipment
mounting holes face the inside.
2. Take one long threaded thumb knob and
insert it through the rail brace and the front
of the LEFT leg. Tighten thumb knob.
(Figure A)
3. Repeat step 2 for right side.
4. Take rear support and insert it into the
rear inside hole on the LEFT leg. (Figure B)
5. Take short threaded thumb knob and
insert it through the rear outside hole on
the LEFT leg. Thread into the rear support.
Tighten knob. (Figure B)
6. Repeat steps 4 and 5 for right side.
7. Take top support. Align hole on the end
of the top support with the top hole on the
LEFT rack rail. Take short threaded thumb
knob and insert it through the rack rail and
top support. Tighten. (Figure C)
8. Repeat step 7 for right side.
9. Recheck all threaded thumb knobs to
make sure they are tight before
you install any equipment.
Figure C
Figure B
Step 4
Step 5
Figure A
Rail Brace
Rail Brace
© 2008 TMP, Inc.
Designed and engineered in the USA
Printed and manufactured in China
www.onstagestands.com
Continued from front
ASSEMBLY INSTRUCTIONS
RS7030 Tabletop Rack Stand
PREPARATION
Remove the following from the box and identify all the parts:
© 2008 TMP, Inc.
Designed and engineered in the USA
Printed and manufactured in China
www.onstagestands.com
Congratulations on your purchase of the RS7030 Tabletop Rack Stand.
Please read the below instructions carefully.
We hope you enjoy your new purchase!
Left rack rail
with bottom leg
Right rack rail
with bottom leg
Rear support
17.75” long
(with stickers)
Top support
19.50” long
(4) .75” short threaded
thumb knobs
(2) 1.25” long threaded
thumb knobs
Package of 48 rack
mounting screws
Continued on back