INSTRUCTIONS FOR THE INSTALLATION AND USE OF BUILT-IN HOT PLATES OCG63FXB1 OCG75FXB OCG90FXB
IMPORTANT SAFETY INSTRUCTIONS We invite you to read this instruction booklet carefully, before installing and using the equipment. It is very important that you keep this booklet together with the equipment for any future consultation. If this equipment should be sold or transferred to another person, make sure that the new user receives the booklet, so that they can learn how to operate the appliance and read the corresponding notice. This is a Class 3 appliance.
INSTRUCTIONS FOR THE USER It is necessary that all the operations regarding the installation, adjustment and adaptation to the type of gas available are carried out by authorised personnel, in conformity with the regulations in force. The specific instructions are described in the booklet section intended for the installer.
INSTRUCTIONS FOR THE USER INSTRUCTIONS FOR THE USER 1 2 3 4 Burner Flame safeguard Injector Ignition spark plug If you have a problem with the cooktop, check the table below. You may be able to solve the problem and this will save you from paying for a service call. You will have to pay for a service call even in the warranty period if the problem is one listed below FAULT POSSIBLE CAUSES Burner will not light even though the sparkler is working.
INSTRUCTIONS FORFOR THETHE INSTALLER INSTRUCTIONS USER CLEANING Before any operation, disconnect the appliance from the electrical supply. Don’t use a steam cleaner for the cleaning the hob. It is advisable to clean the appliance when it is cold. Wash with warm soapy water and rinse with clean water. Where the stainless steel has become extremely dirty with signs of surface discolouration (due to periods of neglect or misuse) use a stainless steel cleaner DO NOT use abrasive scourers or steel wool.
INSTRUCTIONS FORFOR THETHE INSTALLER INSTRUCTIONS USER Adjacent walls, cupboards and protection for combustible materials. Fastening the top Every cook-top is equipped with a special washer. A set of hooks is also supplied for mounting the cook-top. Depending on the type of mounting surface, the suitable type of mounting hook is supplied (hook A or hook B). For the installation proceed as follows: – Remove all loose components from the top.
INSTRUCTIONS FORFOR THETHE INSTALLER INSTRUCTIONS USER OPERATION ON N.G / S.N.G. Gas Connection This appliance is supplied for use with Natural Gas. However, it can be converted for use with LPG. Refer to LP conversion chapter. Supply pipe sizing The total hourly gas consumption for the appliance is shown on the data label. The required supply pressure (i.e. at inlet to appliance regulator) for each gas type is shown on the data label, and given in page "TECHNICAL CHARACTERISTIC TABLES".
INSTRUCTIONS FOR THE USER INSTRUCTIONS FOR THE INSTALLER Electrical connection The appliance is supplied with a standard 10 Amp service cord terminated by a 3-pin plug for connection to a standard household socket. The electrical supply is required to power the electronic ignition system. NOTE: It will be necessary for servicing purposes to disconnect the electrical power supply. The power point should therefore be accessible after the appliance is installed, as specified in the local wiring regulations.
OFF MAXIMUM MINIMUM 1 2 3 4 5 6 F F 7 9 8 8A 9A 9
1 Rapid burner 2 Semi-rapid burner 3 Auxiliary burner 4 Triple ring burner 5 Double ring burner 8 Control knob for burner NG 11,5 MJ/h 6.3 MJ/h 3.4 MJ/h 13.0 MJ/h 12.5 MJ/h Universal LPG 9.6 MJ/h 5.6 MJ/h 3.4 MJ/h 12.0 MJ/h 12.
APPLIANCE DETAILS NORMAL PRESSURE INJECTOR DIAMETER TAPE BY PASS DIAMETER KPa 1/100 mm 1/100 mm Universal LPG 2.75 85 40 9.6 Natural 1.00 15 Adjust. 11.5 Universal LPG 2.75 65 31 5.6 Natural 1.00 110 Adjust. 6.3 Universal LPG 2.75 52 27 3.4 Natural 1.00 80 Adjust. 3.4 TRIPLE CROWN Universal LPG 2.75 95 60 12.0 Natural 1.00 16 Adjust. 13.0 DOUBLE CROWN Universal LPG 2.75 98 60 12.5 Natural 1.00 16 Adjust. 12.
INSTRUCTIONS FOR USING THE MINI TRIVET The mini-trivet included with this cooktop is to be used for cooking vessels of diameter 120mm or smaller Incorrect fitment Correct fitment Examples of positioning of mini-trivet MODEL: OCG63FXB1 MODEL: OCG75FXB MODEL: OCG75FXB 12
