Operation Manual

English
13
CONNECTING RUSH TO YOUR COMPUTER
1 Make sure your computer and the set are switched off.
2 If a printer cable is connected to the parallel port on your
computer, disconnect the printer cable.
3 Connect the supplied parallel cable to the computer's
parallel port. Remove the protective rubber seal from the
DATA I/O socket on the set, then insert the small end of
the cable to DATA I/O.
• IMPORTANT:
– To avoid damage to the set, check the small end of the
cable is the right way up, with the side marked TOP
facing up, before you insert this cable end to DATA I/O.
– Always replace the protective rubber seal when not
connecting RUSH to your computer. Keep the seal in the
carrying pouch or a safe place when removed from the
DATA I/O socket.
4 Turn on the set first, then turn on your computer.
4.5V DC
DATA I/O
VOLUME
DELETE
BOOKMA
TOP
XP SA 101/00 E1 13/6/01 18:42 Page 13