User's Manual

Erasing Learned Buttons, Macros or

Favorite Channels

ERASING COMMANDS

Erasing Commands - Overview

You can erase an individual button with a learned com-

mand, a macro or a favorite channel. You can erase an

ENTIRE Component’s learned command or macro buttons.

You can also erase ALL your learned commands on all

Components or all your macros or favorite channels every-

where.

If you really want a fresh start, it is possible to reset every-

thing to the factory default settings.

Erasing Learned Buttons, Macros or Favorite Channels

STEP 1:

Press and hold the MAIN and

ENT (Enter) buttons at the same

time for approximately 3 sec-

onds, until the word “SETUP” is

displayed at the top of the LCD

screen. This signals that you are

now in setup mode.

IMPORTANT:You now have 30 seconds to

perform the next step while you are in

SETUP mode. If you don’t press a button

within 30 seconds, SETUP will disappear

from the screen, signaling that you have

exited setup mode and you will need to

start over.

STEP 2:

Press a PAGE button to display

Page 2 of Setup.

STEP 3:

Press the ERASE display button

on the LCD screen.

STEP 4:

Press either the LEARN, MACRO

or FAV button. The following

screen appears:

ALL - Erases ALL of the speci-

fied (Learned, Macro or FAV but-

tons everywhere in the RF20)

DEVICE - Erases all learned or

Macro buttons in a single

Component (NOTE: This option

is not available for FAVs.)

KEY - Erases one button only.