Installation Guide

10
Ladder
Phillips Screwdriver
Safety Equipment
3/4” Dome Screws
Dome Washers
Top Adjustable Tube
Solar Dome
Exterior Clear Pure Silicone
TOOLS & PARTS
For angled tube installation, reach and adjust the
Adjustable Tube so it points to the wire in the ceiling,
or adjust the angle of the tube and then insert tube
into flashing.
1
Cover dome screw heads and washers with an
exterior clear pure silicone .
3
Using the 3/4”dome screws and dome washers
(dome washers have the rubber backing – rubber
backing should face the dome), mount the dome on
the ashing aligning the “N” (molded into outer edge
of the dome) towards the North.
2
Dome screws should be snug but do not over tighten
creating pressure against the dome.
TIP
1
Align Toward North
It is easier if 2 people work/turn the tube in opposite
directions to angle the tube as needed.
NOTE
2
Mount Dome
Section-4c
On The Roof