User manual

Section 9, Installing the Distribution Module
inlet of a diaphragm pump and place the hose in a container
filled with a 50/50 mixture of propylene glycol and water (see
Figure 9-8).
2. Connect a hose to the “fill outlet valve” on the distribution
module and place the other end of the hose in the same
container.
Figure 9-8: Initial fill up Oasis system
3. Open both valves on the Distribution module.
4. Turn ON the diaphragm pump. This will prime the pumps in
the Oasis Distribution Module. It may be necessary to fill up the
container with more coolant as the air is being bleed from the
system.
5. Turn on the pump activation switch, located on top of the zone
box, this will activate the pumps inside the distribution module
and fill up both heating loops.
9-8 The Oasis™ Heating Module