User's Manual

Using The Valet Button
Security System Features (cont’d)
SECURECODE
SecureCode allows you to customize the number of valet presses required to perform
an emergency override� This is an extra layer of security that prevents anyone from
overriding the alarm even if they have a key to the vehicle� SecureCode has 2 stages
with the rst requiring 1-9 button valet presses and the second requiring 0-9 valet button
presses� This gives you 99 possible combinations� To program a custom SecureCode,
please refer to user feature #13 on Page 18�
To perform an emergency override with SecureCode, use the following steps:
STEP 1 - With the system armed, enter the vehicle (the alarm will activate)�
STEP 2 - Turn the ignition switch to the “ON” position�
STEP 3 - Within 5 seconds of step 2, press the valet switch to enter the rst digit of your
programmed code�
STEP 4 - After a few seconds, the siren will stop sounding and chirp once (conrming
stage 1)� The siren will then continue sounding�
STEP 5 - Now, within 5 seconds of step 4, press the valet switch to enter the second digit
of your code� If the code is correct, the alarm will disarm�
EMERGENCY OVERRIDE
If you were to lose or break your controller, you’d need to perform an emergency
override to disarm the system and use your vehicle� To do so, use the following steps:
STEP 1 - Enter the vehicle (the alarm should sound)�
STEP 2 - Turn the ignition key to the “ON” position�
STEP 3 - Press the valet switch (located in the window-mount antenna) once�
NOTE: Enter your SecureCode at this time if programmed via user feature #13
STEP 4 - Turn the ignition key “OFF”�
If the code is entered incorrectly, you must turn the ignition key OFF, then back ON to try
again� Additionally, if 2 failed attempts are made, the alarm will ignore any further attempts
for 2 minutes�
WHEN THE SYSTEM TRIGGERS
It will sound the siren/horn and ash the parking lights for 30 seconds (programmable).
When disarming after a trigger event, the siren/horn will chirp 4 times and the parking
lights will ash 4 times instead of the standard 2 times.
LOCK ON TRIGGER: If a door is opened when the system is triggered, it will wait until the
door is closed again, then lock the doors� This feature combats “slim jim” type devices�
STORM SAFE MODE: When the system is triggered, pressing the UNLOCK button will
stop the alarm from sounding but will leave the doors locked�
NUISANCE PREVENTION: If the system pre-warns 5 times within 15 minutes, it will
bypass the zone for the remainder of the 15 minutes before rearming the pre-warn zone�
Additionally, if a full trigger zone is left open, the system will trigger a total of 3 times
before bypassing the zone� Once the zone is closed again, it will re-arm that zone�
10