Instructions / Assembly

ManualsBrandsNuImage Awnings ManualsKitchen60 in. x 12 in. x 39 in. Aluminum Door Canopy

Mounting Bar Edge Rafters (2) Support arms (2) Small Screws (22)

Top Trim Canopy Rafter Adjustable Hinge Brackets (2) Large Screws (8)

Front Gutter Slat Sections (7) Interlock Clips (5)

The KD-2500 Series

Aluminum Door Canopy

Actual Size End Views of door canopy parts for easy reference and assembly:

mounting bar

top

trim

support

arms (2)

slat sections (7)

adjustable hinge

brackets (2)

front gutter

edge

rafter (2)

canopy rafter

Phillips, Regular & Hex head

Screw Drivers or Bits Channel Lock Pliers Power Drill Level Tape Measure

KD-2500 Series Parts Check List:

the kd-2500 shown here with

standard support arms

Required Tools:

slat section seams

Note: Take inventory of all parts prior to assembly

Mounting Top Front Edge Canopy

Bar Trim Gutter Rafter Rafter

It is our recommendation that you read instructions carefully prior to assembly and installation

Summary of content (4 pages)

PAGE 1
The KD-2500 Series Aluminum Door Canopy The KD-2500 shown here with standard support arms It is our recommendation that you read instructions carefully prior to assembly and installation edge rafter mounting bar (2) canopy rafter top trim front gutter slat section seams slat sections (7) support arms (2) adjustable hinge brackets (2) KD-2500 Series Parts Check List: Note: Take inventory of all parts prior to assembly Mounting Bar Edge Rafters (2) Support arms (2) Small Screws (22) Top Tri
PAGE 2
Assembly Instructions The KD-2500 Series Aluminum Door Canopy 1 It is important that the Canopy Slats are assembled properly so that rain water will not leak through the seams where the slats join. The canopy is assembled upside down. Note that the Slat Sections are packaged upside down. (see detail 1) Assemble on a flat surface. Slats have a slight curve to them. Keep them this way for assembly. 1 Caution: Canopy parts may have sharp edges. Use care in assembly.
PAGE 3
8 Top Trim Canopy Rafter Now install Canopy Rafter. Align Canopy Rafter with pre-punched holes in the center of the Top Trim first and secure with small screws, then do the same at the other end of the Canopy Rafter in the center on the Front Gutter and secure with small screws. Note: Door canopies wider than 60” need more than one canopy rafter. Pre-punched holes will guide installation of multiple canopy rafters 9 Next install Interlock Clips.
PAGE 4
Installation Instructions with Sidewings WARNING: Canopies over 84” wide with side wings will also include additional support arms. They must be installed so that no more than 84” of width is unsupported. Arms should be evenly spaced for maximum support See support arm instructions on previous page. 1 If using Sidewings, attach sides to Edge Rafter with small screws using pre-drilled holes. Please note: Support Arms are included on awnings in excess of 84 inches wide.