User's Manual

NUCTECH COMPANY LIMITED
14
▲9. In the future, the software of the smart lock can be adjusted, as needed, to adapt to different
networking modules, realizing the networking function in the future. Refer to the networking manual
for the adding process and application method.
Safety precautions
1
．
The users shall not repair this product at will.
2． Do not close the door for the first time of registration.
3
．
Please keep the password carefully. It is suggested to change the administration password
regularly to prevent the password from being disclosed.
4． Do not operate this product with wet hands, and prevent water, beverages and other liquids
from entering the product, so as to avoid short circuit of circuit board.
5
．
Do not press the electronic touch screen and fingerprint read head with excessive force or
sharp instruments.
6
．
Make sure the door is locked safely when you go out.
7． Do not pull down or lift the sliding cover with excessive force.
8
．
When the battery life is over, please replace all the batteries at the same time. Don’t mix the old
and new batteries together.
9. When the product gives a low-voltage alarm, please replace the batteries in time.
10. It is suggested to place the key outside the house. The mechanical key can be used to unlock
the door in emergency circumstances, and it can give an alarm for one minute.
11. It is suggested to turn on the safety button when you go out, which means the function of
preventing the cat eye is enabled. The on-state is shown in the following figure.
VI Guidance for using smart lock
6.1. [Fingerprint\password] mode
In this mode, users can unlock the door with any valid fingerprint or password registered before. The
specific steps are shown as follows:
(1) Open the sliding cover and wake up the entire system.
(2) Enter any valid fingerprint or password that has been registered.
(3) When the LED indicator light turns green or you hear “Ding Dong”, press down the handle to
open the door.
6.2. [Fingerprint + fingerprint] mode
In this mode, you can unlock the door with any two non-temporary fingerprints registered before. The
specific steps are as follows:
Normal state
On-state
Enter PW
Open sliding cover
Enter FP
Press handle