BUILT-IN GAS HOB INSTALLATION AND USER INSTRUCTIONS PF320SX PF320SGB PF640STX Note: Do not use the hob until you have read the instruction manual
INTRODUCTION Thank you for purchasing a new Gas Hob Rapid burner 10236btu Rapid burner 10236btu Semi-rapid burner 5971btu Semi-rapid burner 5971btu PF320SGB PF320SX Semi-rapid burner 5971btu Semi-rapid burner 5971btu Auxiliary burner 3412btu Triple burner 11259.6btu PF640STX Even if you have used a gas hob before, it is important that you read these instructions thoroughly before starting to cook, paying particular attention to the installation and safety instructions.
CLEANING VITREOUS E N A M E L Hotplate, burner caps, pan supports. Cloth wrung out in hot soapy water. Stubborn stains. Can be removed with a cream paste approved by the Vitreous Enamel Development Council, liquid cleaner or by rubbing with fine steel wool soap pads. NOTE: The pan supports can also be cleaned in the dishwasher. ALUMINIUM Hotplate burner bodies. Similar to paint cleaning above. Use a nylon brush to remove any cleaning materials, water or dirt from the hotplate burner bodies.
GAS SAFETY (INSTALLATION & USE) REGULATIONS 1. It is the law that all gas appliances are installed by competent persons in accordance with current edition of the above regulations. It is in your interest and that of safety to ensure compliance with the law. 2. Repairs or servicing of this product must only be carried out by an authorized agent service and the agent using only approved parts. 3. No attempt must be made to modify this appliance. 4.
UNPACKING THE APPLIANCE Remove all packaging before use and check to make sure that the appliance is in perfect condition. If you have any doubts do not use the appliance and call your supplier. Some parts on the appliance are protected by a plastic film. This protective film must be removed before the appliance is used. We recommend carefully slitting the plastic film along the edges with a sharp knife or pin.
INSERTING AND FIXING THE HOB Before inserting the hob into the work surface, place the adhesive seal (a) around the underside edge of the hob. It is important to fix this gasket evenly, without gaps or overlapping to prevent liquids from seeping underneath the hob. 1. Remove the pan stands and the burner caps then turn the hob upside down, taking care not to damage the ignition plugs and the thermocouples. 2. Place the gasket around the bottom edge of the hob as shown in the illustration overleaf (left). 3.
GAS ADJUSTMENT 6
ELECTRICAL CONNECTION This appliance must be connected by a competent person, using fixed wiring via a double pole switched fused spur outlet with a fuse rating of 3amps, and with a contact separation of at least 3mm in all poles. We recommend that the appliance is connected by a qualified electrician who will comply with I.E.E regulations.
Burners Φ pans in inch Triple Flame 11259.6btu 9.4-10.2 Rapid 10236btu 7.9-8.7 Semi rapid 5971btu 6.3-7.1 Auxiliary 3412btu 4-5.5 TROUBLE SHOOTING Servicing of the hotplates must only be done by an authorized service representative (see back of this booklet) and the hotplate must not be modified. Power must be disconnected before any servicing or maintenance is conducted.
CORRECT DISPOSAL OF THIS PRODUCT: This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled the sustainable reuse of material resources. waste disposal, recycle it responsibly to promote To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
