SDS

ManualsBrandsNOVUS ManualsAcrylic Sheets2.0 oz. Kit Plastic Cleaner, Polish and Scratch Remover

NOVUS PLASTIC POLISH #1 SDS

PAGE 1 OF 11

SAFETY DATA SHEET

Prepared to U.S. OSHA, Canadian WHMIS Standards, and the Global Harmonization Standard

DATE OF PREPARATION: September 8, 2000

DATE OF REVISION: October 21, 2020

1. IDENTIFICATION OF THE SUBSTANCE/MIXTURE AND OF THE COMPANY UNDERTAKING

IDENTIFICATION of the SUBSTANCE or PREPARATION:

TRADE NAME: NOVUS PLASTIC POLISH #1 (Plastic Clean & Shine, NOVUS No 1)

PRODUCT CODES: 7020, 7024, 7026, 7050, 7299, 7302

RELEVANT USES of the SUBSTANCE: Clean and Restore Plastic Surfaces

USES ADVISED AGAINST: Other than Relevant Use, Including Glass Polishing

COMPANY/UNDERTAKING IDENTIFICATION:

U.S. DISTRIBUTOR'S NAME: NOVUS 2 LLC

ADDRESS: 650 Pelham Boulevard, Suite 100

St Paul, MN 55114

CANADIAN DISTRIBUTOR'S NAME: FIX AUTO

ADDRESS: 99 Émilien-Marcoux Suite 101

Blainville, Québec J7C 0B4, Canada

EMERGENCY PHONE (medical): 1-800-420-8036 [24-hrs]

EMAIL ADDRESS FOR SDS INFORMATION: msds-info@novusglass.com

2. HAZARD IDENTIFICATION

This product has been classified under OSHA’s Hazard Communication Standard (29CFR §1910.1200), and Canadian WHMIS (HPR).

This is a self-classification.

GHS CLASSIFICATION:

None

GHS LABEL ELEMENTS:

Signal Word: None

Hazard Statements: None

Precautionary Statements:

Prevention: None

Response: None

Storage: None

Disposal: None

Hazard Symbols/Pictograms: None

Summary of content (11 pages)

PAGE 1
SAFETY DATA SHEET Prepared to U.S. OSHA, Canadian WHMIS Standards, and the Global Harmonization Standard DATE OF PREPARATION: September 8, 2000 DATE OF REVISION: October 21, 2020 1.
PAGE 2
3. COMPOSITION and INFORMATION ON INGREDIENTS SUBSTANCE or MIXTURE: CHEMICAL NAME/CLASS: CHEMICAL NAME Mixture Organic Liquid/Polymer/Water Mixture GHS Classification Hazard Statements/Pictograms CAS # % w/w 67-63-0 0.5% Classification: Flam Liq Cat. 2, Eye Irr Cat. 2A, STOT SE 3 Hazard Statement Codes: H225, H319, H336 Hazard Symbols/Pictograms: GHS02, GHS07 Polydimethylsiloxane, Silanol Terminated 70131-67-8 < 5.0% Classification: Not Applicable Dimethylpolysiloxane 63148-62-9 < 2.
PAGE 3
6. ACCIDENTAL RELEASE MEASURES PERSONAL PRECAUTIONS AND EMERGENCY PROCEDURES: Proper protective equipment should be used. In the event of a spill, clear the area and protect people. Eliminate all sources of ignition before cleanup begins. Use non-sparking tools. The atmosphere must have levels of components lower than those listed in Section 8, (Exposure Controls and Personal Protective Equipment) if applicable, and have at least 19.
PAGE 4
8. EXPOSURE CONTROLS - PERSONAL PROTECTION, Continued CONTROL PARAMETERS: BIOLOGICAL EXPOSURE INDICES: Currently, there are ACGIH Biological Exposure Indices (BEIs) determined for the components of this product, as follows: CHEMICAL: DETERMINANT SAMPLING TIME Isopropanol  Acetone in urine  End of Shift End of Workweek BEI  40 mg/L VENTILATION AND ENGINEERING CONTROLS: Use with adequate ventilation. Use a mechanical fan or vent area to outside.
PAGE 5
9. PHYSICAL and CHEMICAL PROPERTIES, continued FLASH POINT (Pensky-Martens Closed Tester): >93.3°C (200°F). EVAPORATION RATE (nBuAc = 1): Not established; based on ingredients the comparative evaporation rate is expected to be <1. FLAMMABLE LIMITS (in air by volume, %): Not established. VAPOR PRESSURE, mm Hg @ 50C: Not established. RELATIVE VAPOR DENSITY (air = 1): Not established; based on ingredients the relative vapor density is expected to be >1. SPECIFIC GRAVITY (23°C, water = 1): 1.
PAGE 6
11. TOXICOLOGICAL INFORMATION, continued SERIOUS EYE DAMAGE/IRRITATION: Not Classified. Data for Isopropyl Alcohol: Eye Irritancy (rabbit) = 100 mg; severe Eye Irritancy (rabbit) = 10 mg; moderate RESPIRATORY or SKIN SENSITIZATION: Not Classified. GERM CELL MUTAGENICITY: Not Classified. CARCINOGENICITY: Not Classified.
PAGE 7
12. ECOLOGICAL INFORMATION, continued PERSISTENCE AND BIODEGRADABILITY: The product has not been tested for persistence or biodegradability. The components of this product are relatively stable under ambient environmental conditions. Additional environmental data for components of this product are available as follows: DIMETHYLPOLYSILOXANE: Water Solubility: Insoluble. Terrestrial Fate: If released to soil, Dimethyl Siloxane will absorb strongly and will remain essentially immobile.
PAGE 8
15. REGULATORY INFORMATION ADDITIONAL U.S. REGULATIONS: U.S. SARA REPORTING REQUIREMENTS: The components of this product are subject to the reporting requirements of Sections 302, 304, and 313 of Title III of the Superfund Amendments and Reauthorization Act, as follows: CHEMICAL NAME SARA 302 (40 CFR 355, Appendix A) SARA 304 (40 CFR Table 302.4) SARA 313 (40 CFR 372.65) No No Yes Isopropyl Alcohol (mfg-strong acid process) U.S.
PAGE 9
DEFINITIONS OF TERMS A large number of abbreviations and acronyms appear on a SDS. Some of these which are commonly used include the following: CAS #: This is the Chemical Abstract Service Number that uniquely identifies each constituent.
PAGE 10
DEFINITIONS OF TERMS (Continued) NATIONAL RATINGS: FIRE PROTECTION ASSOCIATION HAZARD HEALTH HAZARD: 0 (materials that, under emergency conditions, would offer no hazard beyond that of ordinary combustible materials): Gases and vapors whose LC50 for acute inhalation toxicity is greater than 10,000 ppm. Dusts and mists whose LC50 for acute inhalation toxicity is greater than 200 mg/L. Materials whose LD50 for acute dermal toxicity is greater than 2000 mg/kg.
PAGE 11
DEFINITIONS OF TERMS (Continued) ECOLOGICAL INFORMATION: EC is the effect concentration in water. BCF = Bioconcentration Factor, which is used to determine if a substance will concentrate in lifeforms which consume contaminated plant or animal matter. TLm = median threshold limit; Coefficient of Oil/Water Distribution is represented by log Kow or log Koc and is used to assess a substance’s behavior in the environment. REGULATORY INFORMATION: U.S.