Installation Guide
Waste Outlet
nut and washer
NOT included
Waste outlet
(NOT included)
J-Bend
Wall Bend
waste tube
Decorave
wall ange
(illustraon. 1)
J-Bend
rubber
washer
J-Bend
slip nut
Wall Bend
waste tube
rubber washer
Wall Bend
waste tube
slip nut
J-Bend
Wall Bend
waste tube
Decorave
wall ange
Steps to Complete Your Steps to Complete Your
P-Trap InstallationP-Trap Installation
Carefully plan the installaon and read the instrucons
enrely, before beginning. P-trap locaon, spacing, and
situaonal requirements can vary. 1-1/4” inlet and 1-1/4”
outlet intended for vanity cabinet install. Observe all
local plumbing and building codes. Novao strongly
recommends installaon by a professional plumber or
contractor. IMPORTANT: Lavatory tailpiece must be on
same center-line as the waste outlet connecon.
• Assemble P-trap. Insert the J-Bend’s rubber washer
onto the J-Bend and then secure the J-Bend’s slip nut.
This does NOT have to
be ghtened yet. (g. 1)
• Insert the Wall Bend waste
tube’s
rubber
washer
into the
Wall
Bend
waste tube and slide the Wall
Bend’s slip nut (also known as a
coupling nut) onto the Wall Bend
waste tube. This does NOT have to
be ghtened yet.
(g. 2)
• Shut o the main water supply
there under the cabinet. If replacing an old P-trap,
some water will remain in the J-Bend, have a bucket
or towels ready.
• To nd proper t and alignment, check the t of the
completed P-trap (Wall Bend waste tube and U-Bend
connected -
g. 3) between
the drain’s
tailpiece (NOT
included) and
the main waste
connector (not
included)
coming out
from the wall.
If necessary,
adjust the drain’s tailpipe length to align with waste
connecon height requirements.
(g. 1)
(g. 2)
• Install Wall Bend waste tube (illustraon 1)
Slide decorave wall ange onto the Wall
Bend waste tube. Install the Wall Bend
waste tube into the waste outlet in the
wall (might need to use plumber’s silicone
grease) and hand ghten. Do not ghten
fully. Note: If the WALL BEND WASTE TUBE
is to long, cut to proper length with tubing-
cuer or hacksaw.
(g. 3)