User's Manual
Table Of Contents
- Safety Precautions
- Regulatory Compliance FCC
- Manual Overview
- Introduction
- Technical Specifications
- Physical Interfaces
- Enabler II-G Mounting Reference
- Pin Orientation Reference
- Connectors
- I/O Signal Connector on the Enfora Enabler II-G Module
- Antenna
- Control Connector Signal Descriptions and Functions
- Input Power
- Ring Indicate
- Radio Power/Reset
- Serial Interface (9 Pin I/F) (See table in section 6.5.1 I/O Connector Pin Assignments)
- General Purpose Input/Output Interface (GPIO)
- Analog-To-Digital Input
- Digital-To-Analog Output
- Handset Microphone Input
- Handset Speaker Output
- Headset Microphone Input
- Headset Speaker Output
- Audio Design Note
- Subscriber Identity Module (SIM) Carrier
- Modes of Operation
- SIM Operation
- Software Interface
- Setup and Initialization
- General Setup
- HyperTerminal Configuration for Enabler II-G
- Initialization (AT Command Interface)
- Initial Response to the AT Command
- Sending an Initialization String to the Enfora Enabler II-G Module
- Setting Up the Communication Mode for the Enfora Enabler II-G Module
- Querying the Status of the Enfora Enabler II-G Module
- Setting Module Reporting Parameters for GSM and GPRS
- GSM/SMS Examples
- GPRS Packet Examples
- General Setup
- Integration and Testing
- APPENDIX A - Warranty Repair and Return Policy
- APPENDIX B - Regulations and Compliance
- GCF Approval (Formerly FTA)
- Electromagnetic Compatibility (EMC) and Safety Requirements
- EMC/Safety Requirements for the USA
- Human Exposure Compliance Statement
- Compliance with FCC Regulations
- Unintentional Radiators, Part 15
- Intentional Radiators, Part 24
- Instructions to the Original Equipment Manufacturer (OEM)
- Nationally Recognized Testing Laboratory (NRTL) Approval
- EMC/Safety Requirements for the Countries of the European Union (EU)
- EMC/Safety Requirements for Other Countries
- APPENDIX C - Glossary and Acronyms
- APPENDIX D – Tables And Figures
- APPENDIX E - Contacting Enfora
Integration Guide
Version 1.07
GSM0100PB001 Page 44 1.07 - 1/9/04
10.0 Setup and Initialization
10.1 General Setup
The GPRS modem is controlled through the Modem RS232 port on the development board. Connect a nine
pin straight through serial cable from the Modem RS232 connector to the serial port on the controlling
computer.
Hook up power supply, connect antenna, and install SIM into modem.
10.1.1 HyperTerminal Configuration for Enabler II-G
The following provides an example for setting up a Windows HyperTerminal session that can be used to
experiment with various configurations on the Enabler II-G for controlling computer:
1. Select the connection interface, Direct to Com 1 (or whatever port is the serial port).
Figure 18 HyperTerminal Definition