Installation Guide

Page 3 - PK175 04202017
Passage/Privacy
Installation Instructions
For Pre-Attached
Long Plates
Fits doors
1-3/8” to 1-3/4” thick
Attach the strike plate to the door jamb
using 3/4” long wood screws.
Door
Jamb
Door - Outside
Attach Strike Plate
Door - Inside
Install Interior Half
of Lockset
Insert wood screws
1
Screw in
privacy pin
(Privacy only)
2
1
1
NO POWER
TOOLS!!!
Door - Outside
Insert Wood
Screws
Door - Outside
Install Exterior
Half of Lockset
Emergency
Release Hole
(Privacy Only)
Push spindle button
down and hold during
insertion
1
2
Insert
Spindle
Insert
Spindle
Door - Outside
Latch
Tongue
*
Latch Tongue Note
Bevel Side
Face Plate Curve
Strike Plate Curve
Bevel side of latch tongue should
contact curved end of face plate,
and curved end of strike plate.
Install latch and rotate
the latch tongue
to change handing.
(See page 1 for handing)
Install faceplate with
3/4” wood screws.
1
2
Door - Outside
See Latch Tongue
Note in next panel
*
*
Install
Latch
For 2-3/8”
Backset:
For 2-3/4”
Backset:
Backset
Information
NOTE:
DRILLING
TEMPLATES
FOR
PILOT HOLES
ON SEPARATE
INCLUDED
SHEET