Network Router User Manual

12 PPPoE configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
12-4 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
No. Procedure
2 Configuring the PPPoE service name at the server side
3 Checking the configuration
12.2.2 Enabling PPPoE
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface { ethernet | gigabitethernet } interface-number
The Ethernet interface view appears.
Step 3 Run:
pppoe-server bind virtual-template number
The command binds the interface with the VT.
----End
12.2.3 Configuring the PPPoE service name at the server side
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface { ethernet | gigabitethernet } interface-number
The Ethernet interface view appears.
Step 3 Run:
pppoe-server service-name service-name
The command configures the PPPoE service name.
----End
You must bind the interface to the virtual interface template (VT) before you configure the
name of the PPPoE server on the server interface.
Using the undo pppoe-server bind command, you can cancel the binding by invalidating the
pppoe-server service-name command configured on the interface.