Network Router User Manual

8 Frame relay configuration
Nortel Secure Router 8000 Series
Configuration -WAN Access
8-22 Nortel Networks Inc. Issue 5.3 (
30 March 2009)
z
Run the interface interface-type interface-number command to enter the FR interface
view.
z
Run the interface mfr interface-number command to enter the MFR interface view.
Step 3 Run:
fr lmi type { ansi | nonstandard | q933a }
The FR LMI type is configured.
Step 4 Run:
timer hold seconds
The command configures the polling interval (determined by T391) on the DCE device.
Step 5 Run:
fr lmi n391dte n391-value
The command configures the LMI N391 parameters on the DTE device.
Step 6 Run:
fr lmi n392dte n392-value
The command configures the DTE N392 parameter.
Step 7 Run:
fr lmi n393dte n393-value
The command configures the DTE N393 parameter.
----End
8.5.3 Configuring frame relay LMI and related parameters of DCE
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Choose one of the following steps to enter the corresponding interface view as required.
z
Run the interface interface-type interface-number command to enter the FR interface
view.
z
Run the interface mfr interface-number command to enter the MFR interface view.
Step 3 Run:
fr lmi type { ansi | nonstandard | q933a }
The command configures the FR LMI type.
Step 4 Run:
fr lmi t392dce t392-value