Network Router User Manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 7 LAPB and X.25 configuration
Issue 5.3 (
30 March 2009) Nortel Networks Inc. 7-57
interface Serial1/0/2
link-protocol x25 dce
#
x25 switch svc 100 interface Serial1/0/0
x25 switch svc 200 interface Serial1/0/1
x25 switch svc 300 interface Serial1/0/2
#
return
7.8.7 Example for configuring the SVC function of XOT
Networking requirements
You connect Router B and Router C to each other through the Ethernet interface. Set up a
TCP connection between the routers, through which the X.25 packets can forward. Configure
SVC to implement the SVC XOT function.
Figure 7-17 SVC application networking diagram of XOT
Router A
Serial2/0/0
1.1.1.2/8
Router D
Router B
Eth1/0/0
Eth1/0/0
10.1.1.1/8
Serial2/0/0
Eth1/0/0
10.1.1.2/8
Router C
Serial2/0/0
Eth1/0/0
PC1 PC2
Configuration roadmap
The configuration roadmap is as follows:
1. Configure the link protocol on each interface.
2. Allocate X121 and IP addresses to each interface.
3. Configure the switching function between Router B and Router C.
4. Configure the address mapping and the SVC XOT route.
Data preparation
To complete the configuration, you need the following data:
z
The IP addresses of the interfaces on Router A, Router B, Router C and Router D are
1.1.1.1/8, 10.1.1.1/8, 10.1.1.2/8, and 1.1.1.2/8 respectively.
z
The X121 addresses of Router A and Router D are 1 and 2 respectively.