Server Hardware Installation

30 Chapter 4 Installing the server and peripheral devices

To connect the modem to the server

You require a modem to support remote dial-up access to the CallPilot

server. With a modem, Nortel technical support can connect to your

CallPilot server for troubleshooting purposes. Nortel connects to your server

only when you request technical assistance.

Windows automatically recognizes your modem after you connect it and

power it on. The power light (PWR LED) does not illuminate until the

Windows device driver successfully loads and recognizes the hardware.

To install the modem, you need the following equipment:

•

USB modem

•

RJ-11 analog phone cord

• USB cable (supplied with the modem)

•

an analog line jack

Serial port modems with RS-232 connections are not supported on the 600r.

Step Action

Connect one end of the USB cable into the modem.

Connect the other end of the USB cable into USB 2 on the rear panel.

Connect one end of the telephone cable to the modem RJ-11 jack

labeled LINE.

Connect the other end of the telephone cable to the RJ-11 jack in

the wall.

—End—

To connect the external SCSI tape drive

When you connect an external SCSI tape drive, the device must be

terminated. Your tape drive comes with a terminator. (See Tape drive

terminator in Figure 8 "SCSI tape drive with terminator" (page 31).) The

600r server also comes with a server terminator, a VHDCI (Very High

Density Connection Interface) Ultra320 SCSI terminator. (See Server

terminator in Figure 8 "SCSI tape drive with terminator" (page 31).) In a

previous procedure, you are instructed to connect the server terminator to

the SCSI port. Before you connect an external tape drive to the 600r, you

must remove the server terminator.

Note: If you do not connect a SCSI device to the server, do not remove

the server terminator from the SCSI port.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.0 14 May 2008