Owner's manual

ManualsBrandsNortel Networks ManualsVideo surveillance systems1000

90 Option settings

Table 27

NT6D80 Multi-purpose Serial Data Link card (cont’d.)

RS-232-D DTE or DCE*

RS-422-A DTE

RS-422-A DCE

all off

all on

all off

all on

all off

* RS-232-D DTE and DCE modes are software configured. RS-422-A DTE and DEC modes are

switch configured.

Note: The device number for the MSDL card is configured in LD17 at the prompt DNUM. You must

also set the device number, using switches S9 and S10, on the MSDL card. S9 designates ones

and S10 designates tens. To set the device number as 14, for example, set S10 to 1 and S9 to 4.

NT8D14 Universal Trunk card

Table 28 "NT8D14 vintage AA jumper strap settings" (page 90) through

Table 32 "NT8D14 vintages BA/BB cable loop resistance and loss" (page

92) list option settings for the NT8D14 Universal Trunk card.

Table 28

NT8D14 vintage AA jumper strap settings

Modes Location Jumper strap

Central Office (CO) J1, J2 off

2-way tie trunk (loop dial repeat) J1, J2 off

2-way tie trunk (outgoing/incoming dial) J1, J2 off

Recorded announcement (RAN) J1, J2 off

Paging trunk J1, J2 off

Japan CO/DID operation J1, J2 off

DID operation: loop length > = 2000

/4 J1, J2

DID operation: loop length < 2000

/4 J1, J2 off

Note 1: off = no strap present.

Note 2: Locations (J1, J2) apply to all eight units.

Table 29

NT8D14 vintages BA/BB jumper strap settings-factory standard

Jumper strap settings

Trunk types Loop length J1.X J2.X J3.X J4.X

CO/FX/WATS

2-way tie (LDR)

2-way tie (OAID)

Zero–1524 m (5000 ft)

DID Zero–600 ohms

Off Off

1–2 1–2

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311 02.06 Standard

27 August 2008