Owner's manual

Trunk cards 75

If ALL is specified, all enabled loops (except attendant console

loops) and all shelves on each loop are tested.

If only one loop is being tested and it is disabled, enter ENLL

loop to enable and test a network card associated with the

specified loop. (This command cannot enable network cards

disabled by LD 32.)

If the system response is other than

OK, see Software

Input/Output Reference — Administration (NN43001-611) to

analyze the messages.

3 End the session in LD 30:

****

--End--

Trunk cards

Use the following procedures to test a trunk card.

Procedure 9

Testing a trunk card using a maintenance telephone

Step Action

1 Access the system from a maintenance telephone.

See "Communicating with the Meridian 1" in the Software

Input/Output Reference — Administration (NN43001-611) for

details on accessing the system from a maintenance telephone.

2 Test the trunk unit:

LD 36

TRKlsculoop, shelf, card, and unit numbers

3 If the maintenance telephone is hooked up to a monitor and the

system response is other than OK, see Software Input/Output

Reference — Administration (NN43001-611) to analyze the

messages.

--End--

Procedure 10

Testing a trunk card using a system terminal

Step Action

1 Log into the system:

LOGI (password)

2 Enter:

LD 36

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311 02.06 Standard

27 August 2008