Owner's manual

Introduction 485
Table 203
Trunk and signaling matrix (cont’d.)
Trunk types
Signaling type
CO/FX/
WATS DID Tie RAN Paging CAMA
Continuous operation mode No No No Yes N/A No
Start modes (pulse and level) No No No Yes N/A No
Note: For incoming and outgoing service, DID trunks must be programmed as loop dial repeating.
The NT8D14 Universal trunk Card is an Intelligent Peripheral Equipment
(IPE) device that can be installed in either the NT8D37 IPE Module or the
NT8D11 CE/PE Module. The Universal Trunk card interfaces eight analog
trunk lines to the Meridian 1 switch. Each trunk interface is independently
configurable by software control using the Trunk Administration program
LD 14.
The universal trunk card supports the following trunk types:
• Centralized Automatic Message Accounting (CAMA) trunks
•
Central office (CO), Foreign Exchange (FEX), and Wide Area
Telephone Service (WATS) trunks
•
Direct inward dial (DID) trunks
• TIE trunks: two-way loop dial repeating (LDR) and two-way loop
outgoing automatic incoming dial (OAID)
• Recorded Announcement (RAN) trunks
•
Paging trunks
The universal trunk card also supports Music, Automatic Wake Up, and
Direct Inward System Access (DISA) features.
Table 204 "Trunk and signaling matrix" (page 485) lists the signaling and
trunk types supported by the universal trunk card.
Table 204
Trunk and signaling matrix
Trunk types
Signaling type
CO/FX/
WATS DID Tie RAN Paging CAMA
Loop start Yes No
(see no
te)
No N/A N/A Yes
Ground start Yes No No N/A N/A No
Note: For incoming and outgoing service, DID trunks must be programmed as loop dial repeating.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.