Owner's manual

Operation 47

2 Install the trunk card into the selected slot.

Figure 10

IPE trunk cards installed in an NT8D37 IPE module

3 Install the cable that connects the backplane connector on the

IPE module to the module I/O panel.

4 Connect a 25-pair cable from the module I/O panel connector to

the Main Distribution Frame (MDF).

5 Connect the trunk card output to the selected terminal equipment

at the MDF.

6 Configure the individual trunk interface unit using the Trunk

Administration program (LD 14) and the Trunk Route

Administration program (LD 16).

--End--

Once these steps are complete, the trunk card is ready for use.

Operation

This section describes how trunk cards fit into the CS 1000E, CS 1000M,

and Meridian 1architecture, the buses that carry signals to and from the

trunk cards, and how they connect to terminal equipment. See Table 7

"Differences between IPE parameters" (page 48) for IPE parameters.

Nortel Communication Server 1000

Circuit Card Reference

NN43001-311 02.06 Standard

27 August 2008