Installation Guide
Table Of Contents
- Nokia FastMile 4G Receiver Installation Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ETSI safety guidelines
- 4 ANSI safety guidelines
- 5 Installation overview
- 6 Reviewing safety information
- 7 Identifying package contents
- 8 Reviewing roles and installation prerequisites
- 9 Inserting the SIM card in the Nokia FastMile 4G Receiver
- 10 Determining the mounting location
- 11 Mounting and connecting the Nokia FastMile 4G Receiver
- 12 Troubleshooting
- 12.1 Overview
- 12.2 Subscriber has been registered to a different location
- 12.3 Further installation prevented
- 12.4 SIM not inserted
- 12.5 Failed to connect to the LTE network
- 12.6 Cannot attach to LTE network due to hardware mismatch
- 12.7 The receiver cannot be installed at this position
- 12.8 This subscription ID is not provisioned by the Fastmile Controller
- 12.9 This subscriber ID has already completed a successful installation
- 12.10 Nokia FastMile 4G Receiver firmware upgrade to latest build failed
- 12.11 Nokia FastMile 4G Receiver detached from network
- 12.12 Trace request
- 13 Glossary
- Customer document and product support
Determining the mounting location
62
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-ABBA-TCZZA Issue: 01
The screen that shows that the Nokia FastMile 4G Receiver is being set up, and indicates
the progress of the set up, and indicates that you should keep the Nokia Wireless app open.
After receiving acknowledgment from the Nokia FastMile 4G Receiver of successful receipt
of the configuration file, the Nokia Wireless app informs you that the setup is complete.
Proceed by tapping on “Done”.
16 The Nokia Wireless app uses the signal strength measurement capability of the Nokia
FastMile 4G Receiver to help you find a place to mount the Nokia FastMile 4G Receiver.
The Nokia Wireless app provides the following screens to help you find a place to mount the
Nokia FastMile 4G Receiver based on signal strength measurements:
• swipable information screen that tells you to:
• find a location where the Nokia FastMile 4G Receiver won’t be obstructed (shown in
Figure 24)
• hold the Nokia FastMile 4G Receiver in place and keep it steady (shown in Figure 25)
• try a few locations to find the best signal (shown in Figure 26)
• screen that starts a signal strength measurement by the Nokia FastMile 4G Receiver; you
start a measurement by tapping “Measure Signal”; measurements can take up to five
minutes (shown in Figure 27); for a Compact multi-band model, the signal strength LEDs
will light
• screen that shows a signal strength measurement in progress; you must wait for the
measurement to finish
• screen that shows a signal with average strength, with a recommendation that you take
another measurement
• screen that shows a signal with strong strength, with an indication that this is a good place
to install
• screen that shows a signal with very strong strength, with an indication that this is a good
place to install (shown in Figure 28)
• screen that shows no signal, with a recommendation that you take another measurement
When you have a signal strength measurement that is satisfactory, proceed by tapping on
“Done”.