User's Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Preparatory Tasks
- Chapter 3: Optimization/Calibration
- Introduction to Optimization and Calibration
- Preparing the LMF
- Overview of Packet BTS Files
- LMF Features and Installation Requirements
- LMF File Structure Overview
- LMF Home Directory
- NECF Filename Conventions and Directory Location
- LMF Installation and Update Procedures
- Copy BTS and CBSC CDF (or NECF) Files to the LMF Computer
- Creating a Named HyperTerminal Connection for MMI Communication
- Span Lines - Interface and Isolation
- LMF to BTS Connection
- Switching the Active LAN - LMF I/O Panel 10Base-2 LAN Connection
Preparing the LMF – continued
3-10 1X SC 4812T Lite BTS Optimization/ATP FEB 2005
PRELIMINARY
LMF Installation and Update
Procedures
This section provides information and instructions for installing and
updating the LMF Software and Files.
First Time Installation Sequence:
1. Install Java Runtime Environment (JRE)
2. Install U/WIN K–Shell Emulator
3. Install LMF Application Programs
4. Install/create BTS Folders
NOTE
Any time you install U/WIN, you must install the LMF Software
because the installation of the LMF modifies some of the files that are
installed during the U/Win Installation. Installing U/Win overwrites
these modifications.
There are multiple Binary Image Packages for installation located on the
CD–ROM. When prompted, choose the package that corresponds to the
Switch Software Release that is currently installed.
– Perform the Device Images install after the WinLMF Installation.
– If applicable, a separate CD–ROM of BTS Binaries may be
available for Binary Updates.
Perform the procedure in Table 3-2 to install the LMF Application
Program using the LMF CD–ROM.
Table 3-2: Install the LMF using a CD–ROM Procedure
n Step Action
1 Insert the LMF CD–ROM Disk into your Disk Drive and perform the following as required:
1a If the Set–up Screen appears, follow the instructions displayed on the screen.
1b If the Set–up Screen is not displayed, proceed to Step 2.
2 Click on the Start Button.
3 Select Run.
4 Enter d:\autorun in the Open Box and click OK.
NOTE
If the CD–ROM Drive is not Drive “D”, replace the letter d in the command above with the
correct CD ROM Drive Designator.
3