Caution : You must read this before you proceed Club Chair Picture Label Picture Description QTY A Chair 1 B Wooden leg 4
Label ① Picture Description QTY Washer Rings 7 pcs Before Beginning Assembly: Overview Chair(A) Wooden Leg(B) FRONT FACING This Club Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Club Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Position the chair on its back,as shown. DO NOT place on surface that will harm or damage the upholstery. Unzip to open and remove the 4 wooden legs and washer rings. Close the pocket . Step 2 Install Leg into the Chair by putting a Washer Ring (①) on the threaded stem. Then insert the threaded Stem into the threaded Hole at each Corner of the Bottom of the Chair(A). Tighten by turning Leg clockwise. Repeat the same steps to install the remaining three Legs(B).
Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. Do not place furniture under direct sunlight. Do not place furniture near heating or cooling vents. Do not write on furniture without a padded barrier to protect the surface. Do not place furniture outside . For indoor use only . Not for commercial use. For residential use only . Stains may be removed with mild soap solution and damp cloth. Children should not climb or jump on the furniture.