Caution : You must read this before you proceed BARSTOOL CAUTION : This Barstool is NOT a TOY. Keep your child / children at bay during the assembly process. For moving the Barstool and to prevent damage to the Barstool, two adults are needed to execute this action.
Label Picture Description QTY A Seat Panel 1 B Backrest Panel 1 C Left Leg Panel 1 D Right Left Panel 1 E Footrest 1 F Leg Support Bar 1
Label Picture Description QTY ① Short Screw (M7x40mm) 7 ② Long Screw (M7x70mm) 3 ③ Bolt (M8 x 30mm) 5 ④ Sleeve Nut (M8x15mm) 5 ⑤ Wooden Dowel (φ10x25mm) 9 ⑥ Allen key 1 Before Beginning Assembly: Before Beginning Assembly:
OVERVIEW Backrest Panel (B) Right Leg Panel (D) Seat Panel (A) Left Leg Panel (C) Footrest (E) Leg Support Bar (F) FRONT FACING This Barstool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Barstool parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean, non-marring surface.
Step 2 B 1 6 A Attach Backrest Panel (B) to the Seat Panel (A) as arrow in pictured above. Secure Backrest Panel (B) to the Seat Panel (A) by using Short Screw (①) and Allen Key (⑥) at two sides. Note: Place backrest (B) from inside of Seat Panel (A) then adjust to fix the housing Do not fully tighten the Screws Step 3 3.1 6 3.2 3 5 4 6 D 2 A Tenon A B With assistance from your adult partners, turn pre-assemble part in Step 2 to lay on its side 3.
Step 4 6 6 6 1 D 1 1 F 4.1 4.2 E Prefixed Wooden Dowel 4.1) Attach Leg Support Bar (F) to the Right Leg Panel (D) by using Short Screw (①) and Allen Key(⑥) 4.2) Attach Pre-fixed Wooden Dowel of Footrest (E) to the Right Leg Panel (D) as pictured above and secure by using Short Screw (①) and Allen Key(⑥).
Step 6 If wobble Test again 30cm-50cm Place the Barstool right side up on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Barstool some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the Barstool freely and vertically with all four legs, hitting the ground at the same time. This Drop Test will help to ensure that all the Bolts, Screws and gaps reach full alignment status. Test again for evenness on a LEVEL SURFACE.
Do not put hot items directly on furniture surface Do not clean furniture with harsh cleansers or polish. To obtain the longest lifespan of your outdoor prodcts, minimizing exposure to direct sunlight is recommended. Children should not climb or jump on the furniture. Do not write on furniture without a padded barrier to protect the surface. To obtain the longest lifespan of your outdoor products, avoid extended and lengthy exposure to rain, snow, and direct sunshine.
