Instructions / Assembly

Your Table is ready for use.
This Table can only be used on a flat, level surface.
Step 4
Step 2
Attach Connector(C) between Legs(A) using Bolts(③) and Washers(②) with Allen Key(①)
as pictured above.
Do not fully tighten the Bolts.
Stand the Table up.
Place the Table on a LEVEL SURFACE to check for wobbles.
If it wobbles, adjust the Foot Screws at the bottom of the Legs to achieve levelness.
Once the Table is level, proceed to tighten all Bolts at all joints.
When tightening the Bolts, tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If the Table is not stable, it could lead to damage to the product.
Step 3
Page 3 OF 4