Caution: You must read this before you proceed.
Before Beginning Assembly: Unpack all the parts for a clear overview. Overview Table Top (A) Leg Panel (B) Leg Support Panels (C) This Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Step 1 Open the carton and place all the parts on a clean, non-marring surface. Turn table top upside down, then attach Leg Panel (B) to the Table Top(A) using Bolt(③) and Washer(②) with Allen Key(①) as shown in the picture above. Repeat this process with the other Leg Panel(B) Do not fully tighten the Bolts. Step 2 Attach Leg Support Panel(C) between Leg Panels(B) using Bolt(③) and Washer(②) with Allen Key(①) as shown in the picture above.
Step 3 If wobble Test again 30CM~50CM Place the table on a LEVEL SURFACE to check for wobbles. If it wobbles,with 2 to 3 adult partners, lift the table to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the table freely and vertically with the four legs, hitting the ground, all at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.
