Club Chair Picture 1/5
Label Picture Description Chair : Seat Backrest (A1) and Seat Box ( A2) A QTY A1-1PC A2-1PC A2 A1 B Wooden Legs 2 Wooden Legs 2 Front Legs C Hind Legs Label Picture 1 Description QTY Washer Rings 7 Before Beginning Assembly: 2/5
Step 1 Position the Chair on its back, as shown. Unzip to open and remove the 4 wooden legs. Close the pouch. Step 2 Install the leg into the chair by putting a Washer Ring (improves tightness and security of leg) on the threaded stem,(The use of washer rings are OPTIONAL and is especially useful to help alleviate slight wobbliness); and then insert the threaded stem into the threaded hole at each corner of the bottom of the chair. Tighten by turning leg clockwise.
Step 3 A1 A2 Position yourself behind the chair. Place the back rest(A1) into the body slot(A2). While tilting the back rest slightly forward. Then gently pull the back rest towards you while pushing it down all the way into the Chair Seat slot. located to the rear of the seat box. (as marked by the arrow above). Step 4 Make sure all parts are connected and locked into position before this chair is used.
5/5