Instruction manual

Switch Di700 on and while the ready lamp is on, rotate the dial

and press Set button to select desired mode.

Setting slave flash Di700

When flash is set to SD or SF mode, the of flash power level is

indicated by the lighted LED’s. Rotate the dial to select different

flash power levels of 1/128 – 1/64 – 1/32 – 1/16 – 1/8 – 1/4 – 1/2

– 1/1 (Full) power.

The power you selected is memorized and remains unchanged.

When the flash is set to the Wireless mode, the power level will be

controlled by the Master flash. The remote works on all channels

and with group A/B/C.

Set slave flash at any place and direct the flash head as you

desire. Slave sensor may not respond to the master flash in a

poor sensing situation such as extremely bright condition.

Use the flash stand included. Place Di700 on to the flash stand

which can be placed either on a flat surface, or on the tripod by

the screw.

NOTE

Metal type accessory shoe is not recommended since it may give electric

damage on the electrical contact of the flash hotshoe.