di-GPS Basic digital images GPS Users Guide Ver 1.00 Please visit our website www.di-gps.com for the latest version of the user guide Nikon D2HS, D2X, D2XS and D200 are registered trademark or a trademark of NIKON CORPORATION in the United States and/or other countries. Fujifilm and S5 Pro are registered trademark or a trademark of FUJIFILM U.S.A., Inc. in the United States and/or other countries. Canon and EOS are registered trademark or a trademark of Canon Inc.
Introduction Thank you for purchasing the di-GPS Basic Receiver. The di-GPS Basic (digital images GPS) is specially designed for DSLR (Digital Single-lens reflex) camera. It provides real time position (latitude, longitude, elevation) and the precise time (UTM time) information to your DSLR camera. It records the locations to each digital image file so that you would never forget the exact location where you took the pictures.
Warning / Precaution for Use Keep out of reach of children. This device contains small parts which may pose a choking hazard. Consult a physician immediately if a child swallows any part of this device. Under no circumstances should you attempt to disassemble the product and repair it yourself. Doing so may result in electric shock or product malfunction. Should the product break open as the result of a fall or other accident, send the unit to Dawn Technology Limited service for inspection.
Mounting The di-GPS Basic receiver provides two mounting method. The GPS unit can be mounted on the flash accessory shoe or attached to the camera strap. di-GPS Basic Mounted on the flash accessory shoe. di-GPS Basic attached to the camera strap. Nikon D2HS, D2X, D2XS and D200 are registered trademark or a trademark of NIKON CORPORATION in the United States and/or other countries. Fujifilm and S5 Pro are registered trademark or a trademark of FUJIFILM U.S.A., Inc.
Connect a di-GPS Basic Connect the DSLR camera and di-GPS Basic as described below. 1. Turn off the camera. 2. Remove the Cap from the 10 pin remote terminal on the camera body. 3. Store the Cap in a safe place. 4. Connect the di-GPS Basic to the camera’s 10 pin remote terminal with 10 pin connector. Do not use any extension cord. The 10 pin connector must be aligned with the mark on the camera body. Tighten the locking nut on the 10 pin connector. 5. Turn the camera on. 6.
Status LED indicator for N2 di-GPS fix or not fix LED OFF LED Flashing LED ON : : : DSLR camera not connected No fixed, Signal searching Position Fixed GPS Icon on DSLR camera indicator for N2 di-GPS fix or not fix No GPS icon display GPS icon Flashing GPS icon displayed : : : di-GPS Basic not connected Not fixed. Signal searching Position fixed. Current location information will be recorded in the image files.
Specifications General Chipset SiRF Star III Low Power Frequency L1, 1575.42 MHz C/A code 1.023 MHz chip rate Channels 20 channel all-in-view tracking Sensitivity -159 dBm Accuracy (Open Sky) Position 10 meters, 2D RMS 5 meters, 2D RMS, WAAS enabled Velocity 0.1 m/s Time 1us synchronized to GPS time Datum WGS-84 Acquisition Time (Open sky, stationary requirements) Reacquisition 0.1 sec., average Hot start 1 sec., average Warm start 38 sec., average Cold start 42 sec.
Warranty • • • • • • Dawn Technology Limited guarantees its product, which is determined to be defective or faulty materials and workmanship, for a period of one year after the date of purchase. During the one-year warranty, Dawn Technology will repair or replace the product free of charges. Please keep your original invoice as proof of purchase.
