Operation Manual

117116
• Use two CR2-type 3V lithium batteries
Use two CR2-type 3V lithium batteries.
• Change the batteries well before the end of their life and prepare spare batteries
before important photographic occasions.
• Turn the camera power off when changing batteries
Turn the camera power off before changing batteries and insert the batteries with ´
and ‰ ends positioned correctly.
• Stains on the battery poles may cause lack of contact. Wipe the batteries well with a
dry cloth before installing.
• Use fresh batteries at low temperatures
Battery power diminishes at extremely low temperatures and the camera may not
function properly with old batteries. Use a fresh set of batteries at low temperatures,
keep spare batteries warm, and use them alternately.
• Film advance speed lowers and number of usable film rolls becomes less at low
temperatures. However, battery power may recover when the temperature returns to
normal.
• Do not throw batteries into a fire or short circuit batteries
Do not throw batteries into a fire. Do not short, disassemble, heat or charge batteries.
WARNING
Do not leave
Keep batteries out of children’s reach.
If someone accidentally swallows batteries,
call a doctor immediately.
Notes on Batteries Troubleshooting
LCD panel Viewfinder
©EE blinks ƒEE blinks
©EE blinks ƒEE and ‡
blink
M appears m appears
(When exposure
meter is on)
M blinks m blinks
(appears without (appears without
blinking when blinking when
exposure meter exposure meter
is off) is off)
o––, M and ∑ and m
frame counter blink
blink
©-- blinks ƒ-- blinks
Cause
• CPU Nikkor lens other
than G-type is not set to
its minimum aperture.
• Attached Speedlight is
not set at TTL Auto Flash
in a, Vari-Program or
P mode.
• Batteries are nearing
exhaustion.
• Batteries are just about
exhausted.
• Batteries are exhausted
during film rewind.
• Non-CPU lens is
attached or lens is not
attached.
Page
19,
105
110
17
17
78
18,
106
Remedy
• Set lens to minimum
aperture.
• Set the Speedlight flash
mode to TTL, or set the
camera’s exposure
mode to S, A or M.
• Have fresh ones ready.
• Turn the power off and
replace batteries with
new ones.
• Turn the power off,
replace batteries with
new ones and turn the
power on again. If this
warning appears
frequently, contact
authorised Nikon dealer
or service centre.
• Attach CPU lens. With a
non-CPU lens, set the
exposure mode to M
and set the aperture
with lens’ aperture ring.
MISCELLANEOUS
F75 (En) 03.1.23 11:10 AM Page 116