Installation Guide

T4 LED TROFFER
INSTALLATION INSTRUCTIONS
The installation must only be performed by a licensed electrician.
To prevent death, injury or damage to property, this product must be installed in accordance to
National Electrical Code (NFPA70) in the US or Canadian Electrical Code (CSA 22.1) in Canada.
Disconnect power before installing the product or servicing it.
Wait until xture has cooled down before installing or servicing the xture.
MIN. 90°C SUPPLY CONDUCTORS
Carefully unpack the xture from its packaging. Inspect product for
defects due to shipping.
Locate desired positioning for the xture in ceiling grid.
Turn o power to appropriate circuit at the breaker box.
Place the xture into the T-bar ceiling panel. Secure to grid per state
and local codes.
Remove access plate from Junction Box by removing screw from
end with multiple knockouts. Other end for low voltage connection.
Connect wiring as shown. Grey and Purple wiring are for 0 - 10V
dimming systems. Cap o if not used.
Reattach Junction Box access plate(s) and secure with screw(s).
Turn power on and verify that the xture is lit.
1
2
3
4
5
5
6
7
8
Luminaire
LED Driver
White
Black
Com
Line
GND
Junction Box
Blue
RedRed
Grey
Purple
1-10V (-)
1-10V (+)
Blue
9
NICOR, Inc. | 2200 Midtown Place NE, Albuquerque, NM 87107 | 800.821.6283 | www.nicorlighting.com | August 23, 2016 3:24 PM
6
Model(s):
T4C-14-MV-35
T4C-14-MV-40
T4C-14-MV-50
T4C-22-MV-35
T4C-22-MV-40
T4C-22-MV-50
T4C-24-MV-35
T4C-24-MV-40
T4C-24-MV-50