User's Manual

ManualsBrandsNextivity ManualsElectronicsProvider-Specific Consumer Signal Booster

STEP 3: Route and connect all Cat 5e (or better) cables

STEP 4: Power the Network Unit and Commission the system

LAN Cables are not provided with unit. End-use installer must choose correct LAN / PoE cables. The LAN cable

must be as per requirements of CEC / NEC.

NU Management Connections

A. Once a donor signal is available to the NU (Off-Air or Small Cell), plug in the NU

power supply.

B. Download and launch the QUATRA Management Tool (QMT) app from Google Play

or the Apple App Store.

C. Follow the on-screen prompts to connect to the QUATRA system over Bluetooth

and complete the guided Commissioning steps (you must be within Bluetooth

range of an NU or CU).

D. Once Commissioning is completed, your QUATRA system should be providing service

(the NU and CU front panel LEDs should be solid Green). If an LED is blinking green,

wait for setup to complete. If any red LED indications persist, see Troubleshooting.

LAN

ISP

NU NU

NETWORKED SMART BOOSTER 9

Commission

Settings

• Dashboard

• Alarms

• Help

Software

update

(if needed)

QMT Connects

your QUATRA

to the cloud

Connect to

QUATRA over

Bluetooth

NU CU

Optional QRE

Connect CUs in order CU1, CU2... (recommended)

If unsure of CU placement, leave extra cable to

allow for CU relocating.

If multiple NUs are used for a Site, it is

recommend to daisy chain the NU manage-

ment ports (OUTPUT-LAN-OUTPUT-LAN…),

or connect all NU LAN ports to the same

LAN Subnet.

Do not power up the

Network Unit at this time.

IMPORTA NT

Remember to set Mode when commissioning the Unit. Choices are: Internal Antenna, External

Antenna, or Small Cell.

IMPORTA NT

1) If using a Small Cell, complete Small Cell commissioning before powering up.

2) QUATRA commissioning using QMT or the WAVE portal is required for operation.

IMPORTA NT

• Make sure that Mode is properly set to Internal Antenna, External Antenna, or

Small Cell using QMT or WAVE Portal.

• Make sure donor signal source is operational before powering up QUATRA.

• If any alarms, see Troubleshooting below.

NU to CU Cabling