7306 installation 2092

Recommended Installation by a Professional Plumbing Contractor

Rough in valve Installation

It is strongly recommended that an access panel is built into the roman bath surround.Access

panels allow for ease of trim installation and future possible repairs.

Note: Use Teflon tape or equivalent to seal all threaded joints.

Warning: To prevent severe damage to valve body, any solder/braze process must be per-

formed a min. of 4" from ports.

Valve Installation

Place flange NUT (3) on valve BODY (4).

Insert BODY (4), (blue cold & red hot),

through hole from below mounting sur-

face.

Adjust and secure with additional flange

NUT (3) so that the top of valve stem is

at the correct height from mounting sur-

face. See Figure 1.

Figure 1

Finished Deck

1 3/16”

3/4 NPT

2 9/16”

Spout nipple to be

used for spout

installation

Spout Installation

Apply Teflon tape to spout NIPPLE (1) and

install into base of SPOUT (4).

Insert O-RING (5) into base of SPOUT (4)

and slide spout NIPPLE (1) through center

hole of mounting surface.

Make sure SPOUT (4) is flush with deck and

secure into place with WASHER (2) and flange

NUT (3). See Figure 2.

Figure 2

Ø1”

PLM-7306