Installation Sheet

ManualsBrandsNewport Brass ManualsShower ComponentsNewport Brass Newport 365 Single Handle Pressure Balanced Shower Trim Only less Valve

INSTALLATION INSTRUCTIONS

Tempress Pressure Balancing Valve

Valve Body No. 1-594

as used with Shower Fittings

Description

This valve is precision engineered to provide satisfactory performance provided it is installed and operated in

accordance with our recommendations contained in these instructions. In order to fully enjoy the comfort,

safety and the reliability of this valve, be certain to familiarize yourself with these instructions.

Operation

The pressure balancing cartridge contained in this valve compensates for pressure fluctuations in the water

supply system through a diaphragm-connected pressure balancing mechanism. The outlet temperature will

change by no more than a mere ±2°F (1°C) with a 50% drop in either the hot or cold water pressure.

Even if the coldwater pressure fails completely, the anti-scald design will reduce the flow rate to a safe level

ensuring reliable protection against scalding. The built-in check valves prevent cross flow between the hot and

cold supplies.

Illustration 1

Balance

Pressure Valve

w/ Diverter

Floor Line

Back-to-Back Installation

In back-to-back installations, one cartridge

must be rotated 180 degrees to ensure

proper valve operation.

Standard Installation

Balance

Pressure Valve

w/ Diverter

Floor Line

1-594

1-595 Balance

Pressure Valve

w/ Diverter

Floor Line

Back-to-Back Installation

In back-to-back installations, one cartridge

must be rotated 180 degrees to ensure

proper valve operation.

Standard Installation

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Tempress Pressure Balancing Valve Valve Body No. 1-594 as used with Shower Fittings Description This valve is precision engineered to provide satisfactory performance provided it is installed and operated in accordance with our recommendations contained in these instructions. In order to fully enjoy the comfort, safety and the reliability of this valve, be certain to familiarize yourself with these instructions.
PAGE 2
Before you begin Make sure valve is securely fastened to studs. Be sure to remove trim items, handles, escutcheons and plates before installation. Wrap carefully and store until finished wall is completed. Install the valve by positioning the 1/2” shower outlet in the up position. Finished wall must be within dimensions shown on the chart below. On tiled wall surfaces, grouting must be either flush or raised for proper sealing of the cover plate.
PAGE 3
Illustration 3 14 13 12 11 10 9 8 7 6 5 Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Qty 1 2 1 1 1 1 1 1 4 1 1 1 2 1 1 Description AllThread Nipple Retaining Plate Screw Retaining Plate Oring Full Broach Limit Stop Mechanical Stop Oring Cover Screw Valve Body Cover Cover Oring Cartridge Check Vavle Valve Locking Nut P.N.
PAGE 4
* WARNING Never try to stop dripping by applying extreme force or overtightening the handle. MALFUNCTION CAUSE REMEDY Opening immediately to hot water. Hot and cold water supplies have been connected in reverse. Rotate cartridge. (See Page 3) Water drips after shutting off the valve. Residual water in valve and piping. Allow approximately 38 minutes to drain.* Incorrect setting of the mechanical stop against the stop block causing a partially opened cartridge. Reset the mechanical stop.