NWP 2040 4261

NWP-2040-4261
REV - G
NOTE: Skip to Installations Step 1 if you already installed Brasstech
Rough-in pn#1-339. The use of Rough-in 1-339 is not required but it will
greatly ease the Tub Filler installation.
Site Preparation
NOTICE: This installation instruction assumes the tub filler is mounted on a wood joist support floor surface.
For other flooring substrates such as concrete slab, a suitable cavity must be established within the slab at
the installation location, along with an on-site fabricated mounting bridge over the cavity to allow for
proper mounting of the product. Additionally, the cavity and mounting bridge should be configured to allow
for future access to the plumbed supply connections and to provide space for storing the excess length of
hot and cold inlet hoses.
1. Installation Clearances: Figure 1 illustrates the minimum distance between the tub filler centerline
and a finished wall for preventing handle/wall interference. Maximum distance between tub filler base and
inside edge of tub is depicted to ensure water fills tub.
INSIDE EDGE OF TUB
5
” MAX
3
” MIN
TO WALL
CENTERLINE
1” CLEARANCE
MIN
FINISHED FLOOR
FINISHED WALL
Figure 1
Installation Clear anc es
5-7/8”
1” MIN
TO WALL
CENTERLINE