Installation Sheet

Installation Instructions

Bidet Fittings

Bidet with Drain Actuating Rods

in front of Valves

Model No. 2-235

Congratulations on the purchase

of your Newport Brass product,

an excellent choice, that will give you

years of quality service and enhance

the look and style of your home.

PAGE 1
Installation Instructions Bidet Fittings Bidet with Drain Actuating Rods in front of Valves Model No. 2-235 Congratulations on the purchase of your Newport Brass product, an excellent choice, that will give you years of quality service and enhance the look and style of your home.
PAGE 2
Recommended installation by a Professional Plumbing Contractor Note: The use of petroleum base plumbers putty on our products will nullify the warranty. We recommend the use of clear silicone sealing materials. Installing Hot & Cold Valves The blue marked valve goes into the right side hole, the red marked valve goes into the left side hole. See Figure 1. Place flange NUT (1) and WASHER (2) on valve BODY (3). Insert valve BODY (3) from underside through hole in mounting surface at rear of bidet.
PAGE 3
Installing Drain Components Remove drain PLUG (A) from FLANGE (B). Place FLANGE (B) and white WASHER (C) through sink drain opening. (Clear silicone may be used in place of white washer.) From bottom side of sink, place cone shaped rubber WASHER (D) onto FLANGE (B) and slide up against sink bottom. Note: Cone portion of WASHER (D) to face upward. Slide on clear flat WASHER (E) and secure with flange NUT (F). Place clear WASHER (G) into drain BODY (H) and tighten to FLANGE (B).