Installation Sheet

Installing Hot & Cold Valves
The blue marked valve goes into the right side hole, the red marked valve goes into the left side hole. See Figure 1.
Place flange NUT (1) and WASHER (2) on valve BODY (3).
Insert valve BODY (3) from underside through hole in mounting surface at rear of bidet. Adjust valve to appropriate
height above mounting surface to accomodate handle assembly.
Using additional NUT (1) and WASHER (2) secure valve BODY (3) in place. Before tightening down flange NUT (1),
check handle alignment and stem height by placing handle onto Valve (3). Any adjustments for rotational alignment
must be made to the valve BODY (3), not to the cartridge. See Figure 2.
Installing Diverter Valve / Vacuum Breaker
If unassembled, apply thread sealant to tapered end of ELBOW (7) and
connect to side outlet of diverter VALVE (11).
Place rubber WASHER (8) into “Y” (9) fitting and hand tighten to base
of VALVE (11), over tightening may damage WASHER (8) and affect flow.
Slide one rubber WASHER (10) down onto VALVE (11) base.
Insert VALVE (11) from underside, through center valve hole at rear of
bidet, from topside place rubber WASHER (10), nylon WASHER (13)
and securely tighten with mounting NUT (14).
Thread Escutcheon (15) onto mounting NUT (14)
Place HANDLE (16) onto VALVE (11) stem and secure into place with
SCREW (17). Install CAP (19) onto HANDLE (16). See Figure 3.
Connect large end of 12” supply lines to side outlet of hot and cold
valves and attach small end to “Y” (9) fitting. See Figure 1.
Install Pop-Up Rod Guide
Apply a small amount of clear silicon to underside
of decorative FLANGE (20) and insert through
appropriate bidet hole.
From underside, slide steel WASHER (21) onto
flange NIPPLE (20) and secure in place with NUT
(22). See Figure 4.
Installing Douche Spray Fitting
Apply clear silicon to underside of douche spray BODY (23) and insert through appropri-
ate bowl opening.
Slide rubber WASHER (24) and steel WASHER (25) onto spray BODY (23) from underside
and tighten NUT (26) firmly to achieve water-tight seal. See Figure 5.
Attach end of 24” hose from diverter ELBOW (7) to spray BODY (23). See Figure 1.
Figure 1
Cold Water
Valve
(BLUE)
Diverter Valve
Vacuum Breaker
12” Supply Lines
24” Hose
to Douche Spray
Figure 4
Figure 5
NWP-2-235
21
22
20
24
25
23
26
Hot Water Valve
(RED)
Pop-Up
Knob/Rod
27
Recommended installation by a Professional Plumbing Contractor
Note:
The use of petroleum base plumbers putty on our products will nullify the warranty. We recommend
the use of clear silicone sealing materials.
Figure 3
9
8
11
10
13
14
19
17
16
15
Tapered End
7
a
1/2” NPSM
Inlet
6
4
b
5
4
6
c
2
Outlet
3
1
Figure 2