Installation

ATTACHING WATER SUPPLY CONNECTION (See Fig 2)
· Slide the 1/4” OD supply tube (not included) through compression nut and compression
sleeve. Place insert into end of tube.
· Insert the end of tube into faucet inlet and thread compression nut onto the end of inlet.
3. TEST INSTALLED FAUCET
· With handle in OFF position, turn on water supplies and check all connections for leaks.
Figure 2
Connect to
water supply
(not included)
1/4” OD Tubing
(not included)
Compression
nut
Compression
sleeve
Insert
Faucet inlet
2001 CARNEGIE AVE, SANTA ANA CA 92705
[phone]
WWW.NEWPORTBRASS.COM
NWP-106C Rev D
EN-4290
01/21/21