MIRA-series-quick-start-guide
Table Of Contents
- 1 Overview
- 2 Installation Guide
- 2.1 Safety Precautions
- 2.2 Installation Precautions
- 2.3 OPS Computer Installation
- Step 1. (Optional) Unscrew the M3 screws by hand to remove the OPS Computer shielding cover.
- Step 1. (Optional) Unscrew the M3 screws by hand to remove the OPS Computer shielding cover.
- Step 2. Push the OPS Computer horizontally into the interface card slot.
- Step 3. Pass the fixing screws through the upper and lower lugs and tighten them.
- 3 Power ON/OFF
- 4 Operating the Touch Screen
- 5 Add Shortcut
- 6 Quick Setting Menu
7
About USB port.
Front USB ports and rear USB 3.0/USB 2.0 ports switch connections based on signal sources. If
the current signal source is reading the data from an external product connecting to the port,
please
switch the signal source after the data reading is complete. Otherwise, the data or product
may be damaged.
Special note:
Under the premise of ensuring the display quality, the energy consumption can be reduced
by reducing the brightness of the display.
This product can be paired with various OPS Computers, which can be upgraded or
replaced according to your needs.