WCD-200W Water Dispenser OWNERS MANUAL Read and save these instructions. .
A Name You Can Trust Trust has to be earned and we will earn yours. Customer happiness is the focus of our business. From the factory to the warehouse, from the sales floor to your home, the whole NewAir family promises to provide you with innovative products, exceptional service, and support when you need it the most. Count on NewAir. As a proud NewAir owner, welcome to our family. There are no robots here, real people shipped your product and real people are here to help you.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Specifications ............................................................................................... 3 Safety Information & Warnings ........................................................................... 4 Safe Operation Guidelines ........................................................................... 4 Disposal Guidelines ...................................................................................... 5 Parts List ............
SAFETY INFORMATION & WARNINGS SAFE OPERATION GUIDELINES To reduce the risk of fire, electrical shock and/or injury to persons or property please follow basic safety precautions. Be sure to read all instructions before using this appliance and observe the following safety tips: ALWAYS DO THIS: Always transport your water dispenser in a vertical position and stand on a stable, level surface during use. Keep the water dispenser out of direct sunlight.
Never remove the round grounding prong from the plug and never use a two-prong grounding adaptor. Use of an extension cord is not recommended. Do not pull or place strain on the power cord when moving the appliance. Altering or cutting of power cord, removal of power cord, removal of power plug, or direct wiring can cause serious injury, fire, or loss of property and/or life, and will void the warranty.
PARTS LIST PARTS DIAGRAM 1. top cover 2. heating indicator 3. cooling indicator 4. cold water faucet 5. hot water faucet 6. storage compartment 7. condenser 8. drain valve 9. heating switch 10. cooling switch 11. power supply cord INSTALLATION & SETUP Before connecting the appliance to a power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
The unit must be placed within reach of a properly-rated grounded socket. Never place any obstacles around the air inlet or outlet of the unit. Allow a minimum 6-inch clearance on all sides for efficient operation. OPERATION To dispense hot water, pull the lever on the spigot upwards before pulling both the lever and the spigot downwards. IMPORTANT: Customers are not meant to adjust the temperature by themselves by removing the sticker or screw at the back of the appliance.
5. 6. 7. Turn on the Red (hot) tap until water flows from it. Plug the unit into an appropriate wall outlet. Turn on the switches on the rear of the unit one at a time (do not turn on the switches at the same time). The heating lamp and the cooling lamp will light up. INITIAL CLEANING This unit has been cleaned and sanitized prior to shipping. However, to remove dust accumulated during shipping, we recommend rinsing the water lines and tank upon initial operation: 1.
Do not directly spray water on the surface of the product. CLEANING THE WATER TANKS To periodically clean the water tanks, follow the procedure described for “Initial Cleaning” on page 6 of this manual. Hard water may cause mineral deposits to build up on the interior of the hot water tank, resulting in a decrease in heating capacity. To remove deposits, fill the hot water tank with an aqueous solution of 2% citric acid and leave for two hours. Flush system completely as described above.
TROUBLESHOOTING Problem No water from the faucets. Does not provide hot or cold water. Possible Causes Air entrance has been blocked Too much water has been used in a short time. Electric connection is loose. Electrical leakage. Loud noise. The connection is not good. Uneven footing. Water leakage. The bottle is broken. Solution Take down the bottle and reassemble it. Wait for a while and try again. Make sure the switch is ON and the plug is in the socket. Make sure the plug is properly grounded.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.