Please read and save these instructions.
TABLE OF CONTENTS Important Instructions ........................................................................................ 3 Parts of the Heater .............................................................................................. 5 Grounding and Operating Instructions ........................................................... 5 Specifications ......................................................................................................... 6 Cleaning and Maintenance ................
IMPORTANT SAFETY INSTRUCTIONS PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS HEATER NOTE: There may be a trace of smoke or odor when unit is first operated. Don’t be alarmed. This indicates that a drop of oil fell on the heating coil during the manufacturing process. It will quickly evaporate and should not re-occur. Make sure that the room in which the appliance is located is well ventilated during this operation.
12. To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. 13. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, injury to persons or other damage to property. 14. This heater draws 20 Amps during operation. Be sure to use a dedicated 240VAC, 30A circuit for the heater. 15.
PARTS OF THE HEATER 1. 2. 3. 4. 5. 6. Carrying handle Housing Safety grille Heating element Thermostat control Plug (NEMA #6-30P) GROUNDING AND OPERATING !! IMPORTANT THIS HEATER MUST BE INSTALLED ON THE FLOOR ONLY. Prior to operating the heater, ensure the electrical receptacle is of the configuration and capacity appropriate for the heater. See receptacle configuration in OPERATING INSTRUCTIONS. This heater uses 240 volts. The cord has a plug as shown in #6.
YOUR HEATER IS EQUIPPED WITH A THERMOSTAT: 1. Turn the unit on by turning the thermostat dial away from the OFF position. 2. For faster heat up or to increase the heat output, turn the Thermostat Control knob all the way to the right [MAX]. The thermostat function controls the temperature output. To decrease the heat output, turn the knob counter clockwise. 3. Once the room reaches the desired temperature, slowly turn the Thermostat Control knob counter clockwise until you hear a “click.
TROUBLESHOOTING If your heater fails to operate, please follow these procedures: Problem Unit is not heating. The heater is producing a burning smell. Probable Cause Solution Overheat protection has temporarily deactivated the heater. Turn the heater OFF; unplug it and ALLOW IT TO COOL. Inspect and remove any objects on or adjacent to the heater. Wait 30 minutes before plugging unit back in. To increase the room temperature, adjust thermostat control knob to a higher setting by turning clockwise.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
