User Manual

88
EN
7. Troubleshooting
Problem
▶
Possible causes
▶
Solution
Microphone not
operating
The phantom power supply voltage is
not switched on at the mixing console
or at the power supply equipment
(LEDs not lit up).
Check the corresponding channel settings
The power supply equipment is not
connected to the power supply line or
there is no battery
Check the connection to the power supply
line or check the battery of the power supply
equipment
No signal
transmission
The microphone is not connected
to the correct microphone ampli er
input of the subsequent equipment
Check the signal path
If necessary, activate the appropriate input on
the corresponding channel of the mixing console
Distorted sound Incorrect input sensitivity or gain
setting of subsequent ampli er
Decrease the input sensitivity or gain of the
subsequent ampli er so as to provide su cient
headroom
Wind e ects Use an appropriate windscreen (accessory)
Plosives Use an appropriate popscreen (accessory)
Transmission of structure-borne
noise
Use a suitable elastic suspension (accessory)
Sound is mu ed
and reverberant
Incorrect directional characteristic Check to ensure that the microphone is being
addressed from the correct side, as designated
by the Neumann logo.
8. Technical data and
connector assignments
Permissible atmospheric conditions
1)
Operating temperature range ...........0 °C to +70 °C
Storage temperature range ...........–20 °C to +70 °C
Humidity range .....................0 % to 90 % at +20 °C
0 % … 85 % at +60 °C
Acoustical op. principle .............Pressure gradient
transducer
Directional
patte r n .......................................... O m n id ir ec ti o na l,
wide angle cardioid, cardioid,
hypercardioid,  gure-8
Frequency range ............................ 20 Hz to 20 kHz
Sensitivity
2)
.............................................. 11 mV/Pa
Rated impedance ....................................... 50 ohms
Rated load impedance ......................... 1000 ohms
Signal-to-noise ratio
3)
, CCIR
4)
........................72 dB
Signal-to-noise ratio
3)
, A-weighted
4)
............ 84 dB
Equivalent noise level, CCIR
4)
........................22 dB
Equivalent noise level, A-weighted
4)
..........10 d B-A
Max. SPL
5)
for THD < 0.5 % ........................... 141 dB
with preattenuation –6 dB .......................... 147 dB
with preattenuation –12 dB ........................ 153 dB
Max. output voltage for THD > 0.5 % ........... 10 dBu
Power Supply ...................................................P48
6)
Current consumption ................................... 3.2 mA
Required connectors ................................... XLR 3 F
Weight ............................................................. 445 g
Dimensions .....................................Ø 64 x 145 mm
94 dB SPL equiv. to 1 Pa = 10 μbar
0 dB equiv. to 20 μPa