User's Manual
Table Of Contents
- Contents
- 1. Hardware Overview of the Switch
- 2. Install and Access the Switch in Your Network
- Set Up the Switch in Your Network and Power On the Switch
- Methods to Discover and Access the Switch
- Access the Switch and Discover the IP Address of the Switch
- Use the NETGEAR Insight Mobile App to Access the Switch
- Use the NETGEAR ProSAFE Plus Utility to Access the Switch
- Change the Password
- Register Your Product
- 3. Use VLANS for Traffic Segmentation
- VLAN Overview
- Create Basic Port-Based VLANs
- Assign Ports to Multiple Port-Based VLANs
- Create 802.1Q-Based VLANs in a Basic Configuration
- Create 802.1Q-Based VLANs in an Advanced Configuration
- Add Tagged or Untagged Ports to an 802.1Q-Based VLAN
- Specify a Port PVID for an 802.1Q-Based VLAN
- Manage the Voice VLAN
- 4. Optimize Performance With Quality of Service
- 5. Manage Network Settings
- 6. Manage and Monitor the Switch
- Manage Flow Control
- Manage the Port Speed and the Port Status
- Enable Loop Prevention
- Manage the Power Saving Mode
- Manually Download and Upgrade the Firmware
- Reboot the Switch
- Save the Switch Configuration
- Restore a Saved Switch Configuration
- Return the Switch to Its Factory Default Settings
- Enable Port Mirroring
- View Switch Information or Change the Switch Device Name
- View or Clear the Port Statistics
- 7. Diagnostics and Troubleshooting
- A. Factory Default Settings and Technical Specifications
- B. Mount the Switch
e.
Click the Apply button.
Your settings are saved.
Set Up the LACP System Priority for the Switch
The LACP system priority specifies the link aggregation priority of the switch relative to
the devices at the other ends of the links on which link aggregation is enabled. The
default is 32768. A higher value indicates a lower priority. The value of the priority
applies to all LACP LAGs that you set up on the switch.
To change the LACP system priority:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3.
In the address field of your web browser, enter the IP address of the switch.
The login page displays.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5.
Select System > LAG > LACP Configuration.
The LACP Configuration page displays.
6.
In the LACP System Priority field, enter a number from 1 to 65535.
The default is 32768.
7.
Click the Apply button.
Your settings are saved.
Set Up LACP Port Priority and Time-Out Values
You can set the LACP port priority value and LACP time-out value for a port. By default,
the LACP port priority value for a port is 128 and the time-out value is Long.
User Manual59Manage Network Settings
8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS110EMX