User Manual
Table Of Contents
- Contents
- List of Figures
- I. Introduction
- II. Physical Features
- III. The Home Screen
- IV. Common Questions LinkRunner AT Can Answer
- V. Link-Live Cloud Service
- VI. Setting Up the Tester
- VII. Additional LinkRunner Tools
- VIII. Using AutoTest, Switch, and Cable Test
- IX. Using the PoE Feature
- X. Using the Reflector Feature (Model 2000 only)
- XI. Using the Fiber Connection (Model 2000 only)
- XII. Saving a Report
- XIII. Specifications
Additional LinkRunner Tools
19
User Defined MAC: Disabled
MAC Address: LinkRunner MAC address
Proxy: Disabled
AutoTest Configuration:
Continuous Mode: On
Target: none
PoE Configuration:
Enable PoE: Disabled
Class: Class 1
Connect Configuration:
Security: Disabled
Speed & Duplex: Auto
General Configuration:
Reporting Mode: Local
Cable Unit: Meters
Manage Power: Enabled
Set Language:
English
When you select Restore Factory Defaults, you will be
prompted with a popup. Select OK, then press L.
The tester turns off once it is finished restoring.
Update Firmware
1
Download the LinkRunner firmware update file from the
NetAlly website (http://NetAlly.com/products/
LinkRunner), or contact NetAlly to get the update by
other means.
2
Save the file to your hard disk.
3
Get the latest version of LinkRunner Manager from the
NetAlly website shown in number 1.
4
Start LinkRunner Manager on your PC.
5
Turn on the tester.
6
Select Tools > Firmware Update > select Update.
7
Use the USB cable supplied with the tester to connect
the tester to the PC.
8
In LinkRunner Manager, select LinkRunner > Update
Software.
9
Click Select, find and select the update file (.zip
extension), then click Select.
10
Click Update.
Caution
Do not disconnect the LinkRunner from the PC or
remove the battery during the update.
11
When the transfer is completed, disconnect the USB
cable from the tester.