05) HARDWARE INCLUDED component stable AR | BRE BRENT RARER ANE fa Raa {easel & HE BATAAN PIS package.
dO Assembly ~ Hanging the Preparing for mounting 4 4 install remote control Preparing for mounting em i 4 1.Remove the mounting bracket from the canopy by Positioning the two canopy screws located in the L shaped slots. 2. Remove and save'the two canopy screws in the rand holes, This will enable you ta remove the mounting bracket 1.
QD, Assembly — Attaching the Fan Blades 1.Fastening the blade to the motor | 1.Fasten the Blade to the fan-motor assembly by inserting the alignment post into the slot on the bottom of the: motor and tightening the per-installed Blade screws. 2. Repeat this step for the remaining blade assemblies.
{1 BLL OFF Turn off the lights and @ fatherland same time pe © Fan Control Keys © @ FIR: Changing fan run direction 15 seg) fr Hr Tired dt will turn off the light and Ll the fan when the time is over FRE 5 = & Turn on doff the light {Thigiproaductaosanol have misfeature) © Anti-theoretician natural wind {Iris product does nothingness feature) Note: the remote control must match the same code receiver 11) Remote control wiring diagram | Preponderance | Beg, Black | paternoster | ss fo BRL [ FORAGING 1 FORERU
OEE Put the clip in the center of a blade. turn on the fan and if the shake persists, put the clip in another blade until the shake is reduced. Then this blade will need the counterweight. Place the clip on the blade that needs the counterweight and try the best place to place if, from the center to the tip of the blade, until the wobble disappears. Paste the counterweight on the surface of the blade which near the clip, remove the clip and test the fan. If it keep staggering, put another counterweight.