User Manual
Table Of Contents
- Dishwasher
- en
- Table of contents
- Safety
- Preventing material damage
- Environmental protection and saving energy
- Installation and connection
- Familiarising yourself with your appliance
- Programmes
- Additional functions
- Features
- Before using for the first time
- Water softening system
- Rinse aid system
- Detergent
- Tableware
- Basic operation
- Basic settings
- Home Connect
- Cleaning and servicing
- Troubleshooting
- Transportation, storage and disposal
- Customer Service
- Technical specifications
- Declaration of Conformity
en Troubleshooting
48
Fault Cause Troubleshooting
Coloured coatings (blue, yel-
low, brown) that are difficult
or impossible to remove are
present inside the appliance
or on stainless steel table-
ware.
may not always be possible to com-
pletely remove deposits but they
are harmless to health.
Coloured deposits (yellow,
orange, brown) that are easy
to remove are present inside
the appliance (mainly at the
bottom).
The formation of films is due
to ingredients of food rem-
nants and tap water (limes-
cale) "soaplike".
1. Check the setting of the water
softening system.
2. Add special salt.
→"Adding special salt", Page24
3. If you are using combined deter-
gents (tabs), activate the water
softening system.
Follow the information about deter-
gents.
→"Information on detergents",
Page28
Plastic parts inside the appli-
ance are discoloured.
Plastic parts inside the appli-
ance may become discol-
oured during the life of the
dishwasher.
▶ Discolouration can come about and
will not impair functioning of the ap-
pliance.
Plastic parts are discol-
oured.
Washing temperature is too
low.
▶ Select a programme with a higher
washing temperature.
→"Programmes", Page17
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶ Only remove large remnants of food
and do not prerinse tableware.
Removable streaks are
present on glasses, glass-
ware with a metallic appear-
ance and cutlery.
Amount of rinse aid to be
dispensed is set too high.
▶ Set the rinse aid system to a lower
setting.
No rinse aid has been ad-
ded.
▶ →"Adding rinse aid", Page26
Detergent residue is present
in the final rinse. Lid of the
detergent dispenser is
blocked by tableware items
and will not open fully.
1. Arrange tableware in the top basket
tableware so the tab collecting tray
is not obstructed by tableware.
→"Arrange tableware", Page30
Items of tableware are blocking the
dispenser lid.
2. Do not place tableware or fra-
grance dispensers in the tablet col-
lecting tray.