Extractor hood [en] Instruction manual D55ML66N1, D57ML6.N1.
Ú Table of contents [en]Istrucionmaul Important safety information.....................................................3 Environmental protection ..........................................................5 Saving energy......................................................................................5 Environmentally-friendly disposal.....................................................5 Operating modes........................................................................5 Exhaust air mode .........
In combination with an activated vapour extractor hood, room air is extracted from the kitchen and neighbouring rooms - a partial vacuum is produced if not enough fresh air is supplied. Toxic gases from the chimney or the extraction shaft are sucked back into the living space. ■ Adequate incoming air must therefore always be ensured. ■ An incoming/exhaust air wall box alone will not ensure compliance with the limit.
Causes of damage Caution! Risk of damage due to corrosion. Always switch on the appliance while cooking to avoid condensation. Condensate can produce corrosion damage. Always replace faulty bulbs to prevent the remaining bulbs from overloading. Risk of damage due to ingress of humidity into the electronic circuitry. Never clean operator controls with a wet cloth. Surface damage due to incorrect cleaning. Clean stainless steel surfaces in the direction of the grain only.
Operating the appliance These instructions apply to several appliance variants. It is possible that individual features are described which do not apply to your appliance. Note: Switch on the extractor hood when you start cooking and switch it off again several minutes after you have finished cooking. This is the most effective way of removing the kitchen fumes.
Cleaning and maintenance : Risk of burns! Removing metal grease filter The appliance will become hot during operation, especially near the bulbs. Allow the appliance to cool down before cleaning. 1. Open the filter cover. Note: Grasp the front corners of the filter cover and pull it down in a single, swift motion. : Risk of electric shock! Penetrating moisture may result in an electric shock. Clean the appliance using a damp cloth only.
In the dishwasher: Note: If the metal mesh grease filters are cleaned in the dishwasher, slight discolouration may occur. This has no effect on the function of the metal mesh grease filters. ■ ■ Fitting the activated charcoal filter (only in circulating-air mode) 1. Insert the activated charcoal filter into the extractor hood. Do not clean heavily soiled metal mesh grease filters together with utensils. Place the metal mesh grease filters loosely in the dishwasher.
Fitting the activated charcoal filter (only in circulating-air mode) 1. Remove the magnetic panel. 1. Take the new activated charcoal filter out of its packaging and insert it in the air recirculation module. 2. Take out the activated charcoal filter. 2. Fit the panel such that it is held firmly in place by the magnets. Trouble shooting Malfunctions often have simple explanations. Please read the following notes before calling the after-sales service.
After-sales service Our after-sales service is there for you if your appliance needs to be repaired. We will always find the right solution in order to avoid unnecessary visits from a service technician. Please be aware that a visit by an after-sales engineer will be charged if a problem turns out to be the result of operator error, even during the warranty period. When calling us, please give the product number (E no.) and the production number (FD no.) so that we can provide you with the correct advice.
Constructa-Neff Vertriebs-GmbH Carl-Wery-Straße 34 D-81739 München GERMANY Register your product online www.neff-international.
