Service Manual

Nedap Velos – RealTime Heat detection service manual GB Manual version 1.6 / Page 40
Appendix H Setting up the VPU network configuration
To set up the network configuration make sure the VPU is operational and connected to the
network. Take the IP Utility wizard CD and run it on the connected PC to set the IP address
correctly automatically.
1. Click on the IP utility wizard icon from the IP wizard CD.
2. Turn off the fire wall (in the Control panel - Security centre) and click Next.
3. Click Next.
4. Click on copy advice if this is suggested and click Next.
If the VPU is not found check if the VPU is running and if the network is connected correctly.
Click Back and try again. Contact a network specialist if necessary.
5. Click Next. The IP address will now be changed and a VPU desktop shortcut will be
created on the desktop.
Click OK.
6. Click on OK and on Finish.
7. The VPU desktop shortcut is now on the desktop. Click on it to start the program.